Palani
NAXJA Forum User
- Location
- Kailua Kona, Hawaii
I've been enjoying reading through this thread very much! I'm in the final stages of installing the new Cummins R2.8 crate engine (diesel) into my 97' XJ. I'd love a plug and play module that would integrate my stock sensors (fuel tank level, voltmeter, speedo, etc.) and the CAN data transmitted by the ECM and send that to my stock gauge cluster. I see it's been almost a year since the last post, did a commercially available unit ever get produced?
Currently my gauges are all dead though my speedometer and fuel tank sensors are hooked up to the PCM and showing power, signal output and ground. My cluster is good per the self-diagnosis procedure. Anyone know how to get at least the speedometer and fuel gauges working while I figure out the rest?? I'm guessing it's got something to do with the 5v supply wire to the cam and crank sensors not showing any resistance and no signal input from those sensors. Any way to trick them? Thanks!
Currently my gauges are all dead though my speedometer and fuel tank sensors are hooked up to the PCM and showing power, signal output and ground. My cluster is good per the self-diagnosis procedure. Anyone know how to get at least the speedometer and fuel gauges working while I figure out the rest?? I'm guessing it's got something to do with the 5v supply wire to the cam and crank sensors not showing any resistance and no signal input from those sensors. Any way to trick them? Thanks!