scottsxj
NAXJA Forum User
- Location
- richmond va
im cruisen down the road today, and my jeep starts huming and vibrating, and all of a sudden BANG!!!. U-joint goes out. I want to stop this for good. I figure i need to shim my rear axle. Im sitting at 4 inches of lift in the rear, i measured using the "dirty" method. I have a PORC sye, and a Tom Woods Custom drive shaft. How do i measure what degree shims i need. Also when i put the shaft in i noticed it seemed to be a little short cause i had to pull it put so it would reach all the way. Could this be a reason the u-joint went, because it is putting stress or something on the joint. Thanks for any help
scott
scott