Search results

Up for sale - well maintained 99 sport 2 door, many extras. $4750 OBO http://orangecounty.craigslist.org/cto/2395141458.html

My '99 is cranking a long time (15 sec.) before starting, only sometimes. When it does start, it idles really slow for a few more seconds before running normal. I don't think it's the check valve because when I shut it off and try to restart it does it again right away. I would think if it was...

For sale. 89K miles. Power windows, locks. In the past 6 months - new BFG Long Trail TAs, major tune up, belt, hoses, coolant flush. Reg good through May 2010. Some minor dents and dings. $2600

I'm having trouble getting the foglights to work on my '98. I changed the switch and it didn't fix it. I believe from the wiring diagram, the purple wire is supposed to have 12 volts when then headlights are on - it doesn't. I thought that maybe it could be the relay, so I swapped that with...

I have the older style RE fixed upper control arms - the type that use the factory style bushings. These bushings did not last very long. I was wondering if their small super flex assembly would fit these arms (RE3791). their web site says: The small size is a direct replacement for factory...

'98 XJ with 156K miles. Just want to confirm with the experts, the symptoms are: 1. Slight vibration that has gotten gradually worse over time, only at 70+ MPH. 2. Worse vibration/growl that has happened twice. Can be kind of felt through front passenger floor. 1st time started at low speed...

My '98 was running low pressure, so I installed a high volume Melling oil pump. I had the typical clearance problems, needing to pound on the pan and also bending the pickup up a bit. When done, I hear a clanking noise like the crankshaft is hitting something. With a stethescope, it is loudest...

First - yes, I've searched the posts and didn't see any that directly addressed this. My '98, with 153K miles has about 10 PSI oil pressure at idle when fully warmed up. When it is cold, it has about 50 PSI at idle, and it gets progressivley lower as is warms up - eventually down to 10 PSI...

I just replaced the harmonic balancer on my '98 - the old one had the outer ring wobbling. When starting it up with the new balancer, I was hearing a spark about every 5 seconds or so - coming from the front of the motor. Turns out there is a spark jumping between the outer ring and the...

I recently put a new fuel pump module in my '99 (one of the $110 ebay units). While trying to diagnose a intermittent no start condition, I tested the fuel pressure at the rail. It fluctuates from 77-80 PSI. This seems too high - my 98 tests at 45 PSI. Will this cause problems? Is it most...

The 2001 harness has a 10 pin plug and a 3 pin plug. Leave the 3 pin plug alone. It will fit the 1998. The pin outs for the 2001 10 pin plug C301: 4 3 2 1 10 9 8 7 6 5 1 D1 20VT/BR 2 D2 20WT/BK 3 G32 20BK/LB 4 G31 20VT/LG 5 Z2 20BK/LG 6 F87 20WT/BK 8 P55 20DB/PK 7 X3...

I've bought an overhead console from a 2001 to install into my 1998. I will need to make my own wiring harness. I know there was a good write up on www.paceenterprises.us, but this web site appears to be down (at least I can't get to it). Has anyone done a download of this site - and could you...

Well,I haven't had a great experience ordering factory parts over the internet (at least from the 2 sources I've tried), most recently for a power window regulator for my '99 2-door XJ. Any suggestions on dealers that sell factory parts, preferrably at a discount? Hopefully, west Orange County...

The transmission cooling line on my son's '98 is leaking - on the side that goes by the steering box where the rubber meets the long metal tube. So - can you cut off the metal crimp and get new rubber lines and double hose - clamp each end? Or do you need to spend the $$ to get an entire...

I've read that a 31" will fit in the factory inside location on '96 and earlier w/o the speaker bar. Any idea what the largest spare that will fit a '97 and later with the speaker bar? I know a 31" won't - how about a 29" or 30"?

My Rocky Road adjustable track bar has gone through its second tie rod end in less than 6 months. It looks like the Rusty's frame mount w/ poly end would fit, since they also use the same tie rod end in that configuration - The upgrade costs $89 + $18 shipping, it's not cheap, but less than a...

I'll be in the area very soon and plan to try these two trails. I was wondering if anyone could provide infomation as to difficulty for my XJ. I have a '99. The good: with about 4" lift, 31" BFG MTs. Tow hooks, transfer case skid, rock rails, homebrew disconnects, Wrangler brake lines. Not...

Just like the title says - would a throttle body spacer provide any benefits if you already have the 99+ intake? thx

I need to repair my cracked exhaust manifold. Autozone carries the Felpro MS94790 gasket which they say is for a 98, but not the Felpro MS93094 which they say is for a 99. I know that the intake changed in 99, but does it require a different gasket? Or can I use the one for a 98? Thanks...

I've had my Rocky Road track bar on my '99 for only 2 months - and wheeled on a 3 rated (on a scale of 10) trail only once! It has 1/4" of play in the tie rod end. At first they would not do anything for me, but after persisting they offered to replace it IF I send them the old one first (or...