Recent content by xjhm

The angle is not hard to set, but if you have never done it before it may be confusing....but sounds like the angle is off ...set the angle at the pinion just below the centerline of the shaft...oh and when you install a 3' shim, that doesn't always mean you will have a 3' movement in your...

sold

if you have rusty's adj. ca's then you need these more than you know :)

pm'ed you

ok...

i have two pair of lock nuts from rusty for his control arms... i paid $19.00 plus shipping for each pair and sold the jeep before i got the longarm installed...so i will sell these for $20.00(obo) per pair shipped anywhere in the lower 48...they are new and were never taken out of the...

$50.00 shipped anywhere in the lower 48...obo it was used for 3 mos. untill i put on the winch bumper... it was up before but the buyer never paid... use paypal and i ship the next day :)

brace sold...pending cash :) anybody need to upgrade their rear to 29 spline?

i have for sale a set of 29 sp. spider gears from a '99 8.25 rear(50,000 miles) for sale....with the cross-pin i also have a rusty's steering box brace for an xj for sale(used for a month, then i got a big bumper)... pm me with offers including shipping, and list the city state and zip...

yeah it is a copy of a reciever hitch without the reciever part welded in... i used a piece of 2" square tubing, and welded two pieces of angle to the ends...i used the factory nutstrip to bolt it to... and cut a 1 1/2" X 6" piece of 1/2" stock to run out the back...and the bolted it to the...

a friend at school has a tdi beetle, he gets 48-49 mpg, in eastern ky with the mountains, that is crazy...'02 model, no problems yet.

i went with the no-slip, it came with a cross shaft...mine was an 8.25

just do a budget boost and go with 30" tires and a no-slip, locker... well under $375 and instals in an hour...

auction ended at $8600.00 i need to get $9900.00 out of it, or i may lower it and trade it as stock, any interest on the lift, and parts?

bump