Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Used Chrysler Corporation Jeep manual. $10 with extra cost for shipping based on your zip code. Email to [email protected] is best. Otherwise text or phone 503-930-8393. Located in Tacoma, WA.
Two new 1" wheel spacers with wheel studs pressed into spacers. Wheel studs come with nuts and are 1/2" x 20 thread. 5 x 4.5" bolt circle and 71.6mm center bore. $20 and extra cost for shipping. Shipping cost is dependent upon zip code. Located in Tacoma, WA. Email to [email protected]...
New 23 spline, long shaft, transfer case input gear. Takes wide bearing. This is the early gear cut that matches the early pinion gears. $40 and shipping is extra with cost based on where you are located. If you need it shipped, I will need your zip code so I can figure the shipping cost. I...
0.5" x 1.25" x 62 pitch (62 pins in 31 links) transfer case chain. I bought this chain as part of a project to build a heavy duty 231J transfer case but never used the chain. Located in Tacoma, WA. $20 and shipping is extra if you are not local. Will ship using USPS priority mail small flat...
Ordered the alternator today after talking to a rep at Mean Green. He told me four things:
- Part numbers MG1334, MG1334-D1, and MG1334-D2 are all the same alternator
- For my 1998 Cherokee, the alternator mount will need to be clearance because the MG1334 has a larger case than the stock...
Thanks for the reply. I have been emailing with Jon (5-90) and he will be making cables for me. He has been a great help with planning the electrical upgrades.
Does anyone have actual experience installing this alternator on a 1998 Cherokee XJ (4.0L engine)? Is modification necessary to the alternator or to the mounting bracket?
I have searched and have found threads that indicate modifications are needed on the mounting brackets for earlier years of...
Its true that once you find a useful setting on the Ranchos you don't adjust them much. But, you still have the capability to adjust. If you don't get valving on the Bilsteins you like, its a lot more painful to make a change. I run Rancho 9000s on my XJ and Konis on my street/autocross car...
I run a data recorder plugged in to the OBDII diagnostic port and periodically download the information to my laptop. I didn't get this code until recently.
Suggestion: Use Mobil 1 10w-30 High Mileage oil.
Background: My 1998 XJ 4.0L with 5 speed transmission and 140,000 miles would drop to 0 psi at idle after running hard in the sand. Oil psi at freeway speeds was in the mid 30's. Changing to the 10w-30 Mobil 1 gives 10 psi at hot idle and...
I have Eaton Elockers in front D30 and rear D44 and would buy them again. A couple of installation shops I talked with confused them with the Auburn Ected and strongly recommended against them until I clarified the difference. Those shops had previously had to pull and replace Ected's.
My 1998 XJ with stock 4.0L engine and AX15 transmission continually throws a P0332 code for "Knock Sensor 2 Circuit Low Input (Bank 2)". My forum and internet searchs seem to indicate this engine doesn't have a knock sensor. I don't hear an actual engine knock under hard acceleration. Engine...