Recent content by mark91xjbeef

there was not enough room for a coilover mount and bump stop strike pad plus the drive shaft looked horrible offset that far over. I will probably go with the dom and just find someone to cut the seal step.

I picked up a 90 f350 kingpin and now have to turn it into 79 dimensions. I have already removed the drivers side axle tube. I noticed the inner most side of the tube is machined down to accept the seal. Does anyone know a place that sells replacement tubes I can cut down to the length I need.

pm sent my shop is in clairemont i am up that way all the time

pm me if you are close by and want to get rid of them.

i need a set of stock coils so i can weigh the rear end of my jeep to buy coilovers. they need to be the same springs and hopefully you know what year they are off of. i am willing to pay 20 bucks or you can let me use them for a week. thanks

IUEC local 18 proud and almost every elevator you ride is built and maintianed by one of us.I am proud to pay my dues for what we get in return.

sorry i have a 8.8 got anything else?

i still have both axles. buyers fell through

still have 1 available.

1 is from a 99 xj 3.55 ratio 29 spline. the other is from a 2000 xj 3.55 ratio 29 spline. both are open differentials. the 2000 had the shock mounts cut off other than that both are complete and ready to bolt into your project. 150 o.b.o. each. pm for more info

i tried that last week it didnt seem to make any difference unless i am diong it wrong.

am i looking in the wrong direction. should i be looking more at the mechanical end like tranny internals it has mabye 70000 miles on it. my last one went to 220000 before the 1 to 2 upshift gave up.

the past couple weeks or so when i floor the jeep and it downshifts to 1 or 2 the rpm will climb up to 5200 then bounce off the limiter. to shift i have to let off the gas and it will upshift normally. it only seems to happen a WOT. I tested the solenoids all 13.1-13.3 ohms. tcu has power and a...

i have 2 in my yard both 29 spline 3:55 ratio

the tires are brand new and up to psi. i will try and change the fluid and see what happens.