Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I was curious if anyone knows why front axles bend. I just find it interesting since they are in a tube and have joints at the end instead of flanges. Just curious. I can understand how they could twist torsionaly.
I just came across a near free 98ZJ 4x4
I have an 89 XJ AW4 242 D30/D35, 3.5inch lift SYE. Keeping it
Would it be to my advantage to swap parts off of the ZJ, I know the rear axle wouldn't fit without modifying.
Or should I leave the ZJ alone? And as they sit both run fine.
I found it!!!! After looking at my yoke only for the millionth time. After this shaft swap I noticed there was a small amount of play at the yoke. I checked the joints when I had it out. I measured the yoke and the difference and it was .02" wider. I had a spare at home and looked at it and...
I took the rear shaft out and it made some improvements although I got a new set of vibes running the front alone. I think I'll get it balanced and see what happens.
Replaced the tires finally!, I'd say it got 75% better. I'm still amazed that the old tires still looked good but were wreaking havoc. I still have a slight vibe going at high speed but I think that may be the drive shaft. I'll play with that some more to see if it helps. As of right now the...
With the front wheels up, have some one apply the brake an see which is not working. Then have them release the pedal and see if either side is dragging or holding. Then when you find the side open the bleeder and see if it releases, if it doesn't open the fitting at the top of the hose. If it...