before the crawl my junk needs.....

[94xjsport94]

I need to find a new place to mount my CB antenna so i can stop destroying coax cables, check the fluids (I should probably pull the diff covers...), wrap my exhaust, look into my SYE leak if i can get ahold of JB Conversions, cage tie ins, and interior storage. And hope i don't break anything too major at Choccolocco in two weeks again. A good weekends work and i should be ready.

 

[Ghost]

Well this will be one thing off the list......

 

[Cottontail]

new u-joint in front drive shaft - DONE
new driveshaft straps - DONE
new front pinion yoke - DONE
repair spring holder on drivers side DONE
repair snapped off bolt in the differential housing -DONE
Replace fluid in rear axle DONE
Repair broken track bar DONE
Get one new 31" MT DONE
Pick up spare long shaft DONE
Pick up spare short shaft DONE
Route cowl air induction system DONE
Mount new spare on factory rim
New negative battery cable
New ball joints DONE
New tie rod to pitman arm DONE
New tie rod to left steering knuckle DONE
New tie rod end at the left steering knuckle DONE
Replace Durango steering box with OEM Replace front skid plate
Oil change DONE
New brake calipers on front axle
New inner axle oil seals

 

[1989TwoDoor]

To do:
Register for crawl - Done
Swap out rear leaves - Done
Install shackle relocation kit - Done
Weld cage to shackle relocation kit
Raise the shock mounts on rear axle
Trim the shackles
Double check brakes/adjust drums
Replace idler pulley?
Replace windshield, if time alows

 

[Ghost]

Drag link and winch..... I sure could use a spare shaft but IDK that will happen. Need to fix that damn seat too!

Cut my seat out yesterday. So the seat will get fixed..... :hang:

 

[Wayne Sihler]

Replaced cracked APN header with an APT Header(still china junk), does not leak,,,now,,,,,

 

[94xjsport94]

Install the electric line lock
Check the tranny level
Finish half doors
Finish cage tie ins
Acquire a trailer

 

[~Spanky~]

Install New lights (if it gets here ;-)
Oil & Filter
Install rear locker (If it gets here)
Grease it all up
Make it shine so it can get dirty!:wave1::repair:

 

[JRT1393]

Get my front axle and locker installed.
Fix horrid exhaust leak

 

[Ghost]

Install New lights (if it gets here ;-)
Oil & Filter
Install rear locker (If it gets here)
Grease it all up
Make it shine so it can get dirty!:wave1::repair:

locker?

 

[PacificEd]

Oil & filter
Diff fluids
Grease everything
Install new-to-me-seats
Install A/C delete pulley and bracket
New belt and idler pulley
Delete vacuum lines hoping to fix high idle situation
Delete A/C junk so I have more room in the engine bay

 

[043500]

.

Got the EGT and trans temp gauges installed in the new to me tow pig. Also put new tires on it and had the front end aligned. Expecting a fuel control actuator today as I think the original is going out (20 min job) and a spare lift pump just in case. ALL DONE (FCA was bad so now it's running right)!!!

So other than getting my winch plate welded to the brackets DONE!!! and then installing the winch itself TONIGHT OR TOMORROW!!!...all I should have left to do is to have trailer ramps made NEXT WEEK I HOPE and start sleeping less and less since I'm getting more and more excited to go!!

And just double check all the MJ's fluid.

 

[POLAR_JEEP_04]

Build and instal my front axle and build track bar and steering, Instal front tow points, build swaybars mounts, instal arb compressor... Plexi window if I have time.

 

[POLAR_JEEP_04]

I gotta rip out all the AC and ABS crap if I have time too.

 

[Ghost]

Fix hole in floor, build a seat mount and build a shift lever shaft...... UGH!

 

[xcalibur223]

Ok time to start the list
Install 235s
Install front tow hooks
Oil Change
Tune up
Spark plugs
Change CPS
Register, plate, and inspect it

 

[~Spanky~]

locker?

Yes, a real store bought one.
I figured, if it's up 3.5" on 33" BFG...might as well have both rears pushing it up the hill.\Why the H311 not? :scottm:

 

[bwfdrums]

New bumper is supposed to come in today! So I got that going for me, haha. We shall see if I actually find time to work on it this busy weekend.

 

[RedHeep]

Yes, a real store bought one.
I figured, if it's up 3.5" on 33" BFG...might as well have both rears pushing it up the hill.\Why the H311 not? :scottm:

A front locker will get you farther than a rear one.

 

[BRIANHO13]

A front and rear locker will get you farther than a rear one.

Fixed