TheSandman
NAXJA Forum User
- Location
- Richmond, VA
So I installed my ballistic setup, which is a stout setup and I'm extremely pleased with so far. I knew I was going to have bumpsteer problems and have been trying to figure out how to correct it. I bought a new trackbar mount so I can fab up a new track bar.
I was thinking though, could I put a shorter pitman to help with the draglink angle? Would that limit my suspension travel with the steering setup?
Also, what are you guys using, joint wise when fabbing a track bar? I was thinking using something close to the RE design with a rubber bushing on the diff side and flex joint at the body. Or flex joints on both sides?
Any comments & opinions will help!
Thanks
I was thinking though, could I put a shorter pitman to help with the draglink angle? Would that limit my suspension travel with the steering setup?
Also, what are you guys using, joint wise when fabbing a track bar? I was thinking using something close to the RE design with a rubber bushing on the diff side and flex joint at the body. Or flex joints on both sides?
Any comments & opinions will help!
Thanks