i have been searching for a long time and even called Warn, without success. they said they do not have a published torque spec for the four main mounting bolts on my m8000. normally, i wouldn't be that worried but i stripped them out last time (bad habbit i know) and figure i should do it right this time. i could only find grade 5 square nuts at the hardware store and i need square nuts because two of them are not accessible to put a wrench on. bolts are grade 8, 3/8 coarse thread. couldn't find fine threaded square nuts either. looks like some people have read 32-35 ft.-lbs. i think the last time i stripped them out they were around 55-75 ft.lbs. any input would be helpful! i don't want to come close to stripping them again and have my winch pull off the bumper...
Thanks
Thanks