61scout80
NAXJA Forum User
- Location
- Chandler, az (alma school/202)
I bought a previously disassembled 94 2.5l xj. everything from the flywheel back was discarded, so i am trying to piece it back together. Some time ago i found a tranny on craigslist that was listed as an xj ax5. that's what this used to have so i picked it up.
well, today i tried to put it in. the trans mount i bought from autozone doesn't match the transmission i have, but does match the cross member. the bell housing lines up and bolted in perfectly, and the input shaft mated up fine. but the flat spot on the transmission where it looks like the mount should go is pretty far forward in comparison to the cross member. either i bought the wrong type of trans or i'm doing something seriously wrong.
is the wrangler tranny different? Any ideas of what i could be doing wrong here if it isn't??
well, today i tried to put it in. the trans mount i bought from autozone doesn't match the transmission i have, but does match the cross member. the bell housing lines up and bolted in perfectly, and the input shaft mated up fine. but the flat spot on the transmission where it looks like the mount should go is pretty far forward in comparison to the cross member. either i bought the wrong type of trans or i'm doing something seriously wrong.
is the wrangler tranny different? Any ideas of what i could be doing wrong here if it isn't??