gman
NAXJA Forum User
- Location
- Virgin Islands
About 6 months ago I had a new clutch Pressure plate and a release bearing installed. about 2 months ago I installed a new clutch master cylinder, everything was shifting quite well. Yesterday on my way to work I encountered some difficulty shifting out of first to second while going up hill, therefore I had to maintain that gear all the way up. Once I got to the top I was able to neutralize it and attempt to get it in other gears, it engaged 4th gear one time after lots of pumping on the clutch, when I took it out of 4th and attempted others it never engaged, and never re-engaged 4th. The peddle feels like it have a little pressure at the end of the depress, but not enough pressure to shift. :wantyou: I would appreciate any assistance or suggestions I may get. There is no noticable leaks, and the reservoir for the clutch master is full to the required line with fluid, did check during this ordeal.
Last edited: