Sponge Bob
Attitude Racing
- Location
- Mokena,ILL
Changed direction and added hydro
This saw cuts like butter even at 1/2 thick
This saw cuts like butter even at 1/2 thick
-
Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.
Tube bender mounted and ready
- Thread starter Sponge Bob
- Start date
Sponge Bob
Attitude Racing
- Location
- Mokena,ILL
Dry cut at 1450 rpm no coolant just got it from Loews for 215 but just found it at Menards for 199. i Can cut thin slivers of steel and best of all it is just warm to the touch after cutting. Check youtube for evolution rage2 saw 14". I have had abrasive saws that shoot sparks and leave you cleaning up the edges afterwards. this saw leaves a ocasional burr for clean up. The blades are expensive but they claim to get 800 cuts on average. i have cut 1/2 plate and 3/8 angle iron with no problems.
www.evolutionrage.com
www.evolutionrage.com
Boss Cherokee
NAXJA Forum User
- Location
- Riverside Calif.
How much was bender & from ? Looks like Harbor Freight air hydraulic jack.
Sponge Bob
Attitude Racing
- Location
- Mokena,ILL
pro tools is the bender with harbor jack mounted with my clamp
2stix
NAXJA Forum User
- Location
- fallbrook Ca.
what gears are you running on that bender?
dude, thats funny right there. never seen a pinion gear used for that before. just be careful not to bump it and crack the cylinder base open.
dude, thats funny right there. never seen a pinion gear used for that before. just be careful not to bump it and crack the cylinder base open.
Sponge Bob
Attitude Racing
- Location
- Mokena,ILL
4.88 dana 30. The pin i used should fail first i hope. you win the booby prize for knowing what it is. Just trying to be green with my broken parts
