had a quick question. I have a HP dana 44 from a f150. I want to try the radius arm setup (instead of the 4-link thats on right now) but am running into difficulty. When I mount up the radius arms to the axle, the radius arm end (stock threaded side) is about 10-12" lower then my crossmember. So if I was to force it up to the bracket (attached to the crossmember) the pinion angle would be way to high (pinion up in the air). I purchased 7 degree c bushings and still nothing....Has anybody run into the same problem? What are your recomendations?
thanks
-Red
thanks
-Red