blaisetd
NAXJA Forum User
- Location
- Westlake, Louisiana (Southwest)
So yesterday afternoon I was wrapping up my SYE install (Omix-Ada from www.4wheelerssupply.com). I decided to shift through the gears to check it out. I had not installed the front driveshaft or any of the shift linkages yet. Running through the gears I noticed that in 2 HI the front yoke would not “unlock”/staying in 4 hi or low not sure. Also, I lost my dash part time light. Stupid question; does the lack of front drive shaft have anything to do with it not shifting out of 4WD? Did I cut too much off (1") the shift rail and this is what is causing the VAC switch not to turn of my dash light? Just thought I’d see if anyone had any ideas before I open her back up? Does anybody have any good diagrams of this case or is it in the FSM? Thanks in advance blaise
1990 4.0 auto np 231
1990 4.0 auto np 231