JSmall
NAXJA Forum User
- Location
- Sherwood, OR
I am using 1.75 x .120 DOM that I have leftover from the cage install I did on my brothers Honda. They are going to resemble the guards on Custom4x4fabrication.com. I am going to run three legs to the uni-body and have six mounting locations on the pinch seam. My question is… how much clearance should there be between the lower tube and the bottom of the Jeep? I know the angle on the pinch seam needs to be mounted so it is touching the underbody, and I know I can have the other tube (top) mounted as far away from the side of the body as I want. I am not sure about the tube that runs under the body next to the pinch seam. Do I have it touching the underbody or have it sitting off the body some? If anyone has any input I would appreciate it. Sorry if none of this makes sense, but I have it down on paper and I just need to make sure I have the dimensions correct before I start fabricating these.
Thanks
Jaromy
Thanks
Jaromy
Last edited: