So the other day i did a head gasket on my 1990 Renix XJ with the 4.0, i put it all back together and it cranks over has fuel pressure and compression but didnt fire. I check the rotor and its right on the cylinder it should be. Then i pulled and plug and cranked it and it has no spark from dist to plug. Then i checked if i had spark from coil to dist and nothing, no spark at all. Weird because the night before i did the headgasket it was perfect.
I pulled the ground to the head and cleaned it and tightened it back down, i dont see any plugs unplugged and it all looks good.
I see the two rods that click into the base for the coil but what is the third flat piece, it looks as if something should clip onto it. And when i found it, it looked like this with nothing hooked to it.
Any help would be much appreciated! thanks
I pulled the ground to the head and cleaned it and tightened it back down, i dont see any plugs unplugged and it all looks good.
I see the two rods that click into the base for the coil but what is the third flat piece, it looks as if something should clip onto it. And when i found it, it looked like this with nothing hooked to it.
Any help would be much appreciated! thanks