- Location
- Westminster, SoCal
that's one option.. but I'm hoping I can find this TRE.BrettM said:why not ream the knuckle for that size anyway from the top, then you get a bigger/stronger TRE and raise the tie-rod.
Capt. Nemo said:PM me your address, and I'll send you my bent one. Seriously.
The diameter of the very bottom of the taper where it is threaded and the castle nut goes is much larger than the stock D30 TRE hole. In order for you to make this work even with D44 knuckles, reaming is involved.
This is the reamer I used to ream the knuckles and TRE's:
http://buy1.snapon.com/catalog/item...4&group_ID=946&store=snapon-store&dir=catalog
I don't think that's what I'm looking for: the one with the hole in it is extremely long and I'm looking for a short one.RCP Phx said:Pass side YJ!They run an inverted-T set-up.
Kejtar said:Hmmm did you run inverted T or inverted Y?
When using that reamer did you first drill it out then ream it out? Also in regards to reaming the hole out, aren't you worried about weakening the knuckle? Cause I'd rather bust a TRE then break the knuckle on the trail.
I've got one that looks just like that.Capt. Nemo said:PM me your address, and I'll send you my bent one. Seriously.
DaffyXJ said:The hole in the TRE is for the drag link in an inverted T set up. Supposed you could run a stabilizer in the tre also if running a cross over steering setup.
http://www.tqci.net/~scot/steeringa.jpg