Forceful Llama
NAXJA Forum User
- Location
- MOdesto
94 4.0 hp30
Made a mistake and bent an axle shaft ear while changing ujoints last week. Got a set of replacement axle shafts off another member here with unit bearings attached . Using the info in this post
http://www.jeepforum.com/forum/f11/any-difference-hubs-360959/
I now have a unit bearing from 99.5 on. I matched the correct cast rotor from a 2000 accordingly from autozone. After driving it yesterday I experienced horrible grinding/rubbing noises coming from the front end. I had assumed maybe the unit bearing was bad. Upon removing the wheel and rotor today I noticed fresh grind mark on my dust shield and knuckle. What am I missing here? Did I read the measurements off the post wrong? First picture is what's currently installed
Made a mistake and bent an axle shaft ear while changing ujoints last week. Got a set of replacement axle shafts off another member here with unit bearings attached . Using the info in this post
http://www.jeepforum.com/forum/f11/any-difference-hubs-360959/
I now have a unit bearing from 99.5 on. I matched the correct cast rotor from a 2000 accordingly from autozone. After driving it yesterday I experienced horrible grinding/rubbing noises coming from the front end. I had assumed maybe the unit bearing was bad. Upon removing the wheel and rotor today I noticed fresh grind mark on my dust shield and knuckle. What am I missing here? Did I read the measurements off the post wrong? First picture is what's currently installed