Ok don't even think I'm steeeewwwpid enough to think about bolting these on and seeing what destruction happens when I goto open the door. I'm just wondering if anyone has ever done/tried this with some "modifications" of course.
This winter/spring I plan on removing the front fenders, building a flat/tube fender so it won't be a problem to build the support I need into that for the hinge. The door side however...my plan is to gut the door of as much material as possible, lighten it up. Then reinforce the front area by plating the new hinge area with 14 ga, weld in some reinforcements that will tie that whole front area together (outer skin, inner, and front where original hinges are).
Yeah it's a lot of work when there's easier ways to make the doors removeable, but heck why not?!
This winter/spring I plan on removing the front fenders, building a flat/tube fender so it won't be a problem to build the support I need into that for the hinge. The door side however...my plan is to gut the door of as much material as possible, lighten it up. Then reinforce the front area by plating the new hinge area with 14 ga, weld in some reinforcements that will tie that whole front area together (outer skin, inner, and front where original hinges are).
Yeah it's a lot of work when there's easier ways to make the doors removeable, but heck why not?!