jeepownzme
NAXJA Member #1151
- Location
- Colorado
I have a 242 transfer case and recently received a RE H&T Kit along with the spicer companion flange from Currie Ent. (Part Number 88-CFDA). My plan was to use these parts in conjunction with an extra front D/S I have.
My problem is: As I was test fitting all of the parts. I noticed that the spicer companion flange will not sit flush against the H&T flange due to the length of the collar that slides over the tailshaft of the TC. There is approximately a 3/8" space between the bolt surfaces. Do I need to have the companion flange machined a little deeper, or did I receive the wrong part from Currie? I was told that this is the same part as Spicer part #211229x.
Does anyone know if NAPA carries the correct spicer companion flange?
Thanks for your help...
My problem is: As I was test fitting all of the parts. I noticed that the spicer companion flange will not sit flush against the H&T flange due to the length of the collar that slides over the tailshaft of the TC. There is approximately a 3/8" space between the bolt surfaces. Do I need to have the companion flange machined a little deeper, or did I receive the wrong part from Currie? I was told that this is the same part as Spicer part #211229x.
Does anyone know if NAPA carries the correct spicer companion flange?
Thanks for your help...