Apparently "drainc*ck" is a swear wordbcmaxx said:XXXX???
ehall said:I disagree with pulling the hose. The grill comes off with 8 screws in about 2 minutes and the petcock is right there.
iwannadie said:Then, attach a rubber hose to the drain, stick a wrench in there and loosen it a few turns. Coolant runs down into a bucket and everything stays nice and clean.
Wayne Sihler said:There is nothing to attach a hose to. It is not like a brass drain valve,just a big hole
Wayne
On my 96 that sort of works. On the 97 and newer it is tough to access that way. Up from the bottom is ok but far from reasonable. Even on the 96 why should a person need to take 8 screws out to loosen 1 valve?ehall said:I disagree with pulling the hose. The grill comes off with 8 screws in about 2 minutes and the petcock is right there.
iwannadie said:Mine is a drain valve, a piece of thin heater hose slips right on it. Replace your plug with a drain valve maybe?
NWPhotog said:Have to agree the OEM plug has no place for a tube. Nothing wrong with upgrading but how tough to get it right to begin with?