Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I think I used a manifold bolt on one end, and something else on the other end/side, but I don't remember what the other one was. I used the two points strapped together with some tubular webbing (since I have alot of it) with the hoist attached in the middle.
After looking at it, I see that this is exactly what I did. Of course the center point changes according to what is hooked up, to balance it (mine was rather far back since I removed the entire engine/trans/tc at once)
On mine I used two chains. On the passenger side I used the bolt for the dipstick and one for the AC compressor mount (not on the mount itself, but on the engine block. On the driver's side I used a bolt for the power steering bracket and there was an empty hole on the rear that I used.