footdale
NAXJA Forum User
- Location
- Albuquerque, NM
Just replaced my stock track bar and mount with Kevin's TB conversion that uses the ORGS TB. This bar uses the stock 10mm bolt for the axle end mounting. But the bushing ID is like 11+mm! I was concerned that there would be tons of play at this joint during weight transfers, but Kevin convinced me that this was cool and it would be fine. Put it together and it is super solid like he said.
I'm just curious as to why it doesn't move around. any ideas?? There was just a little play in the TRE on the stock bar and everytime I made a turn it sounded like it was going to fall apart. The stock bushing was a close fit to the bolt, but ORGS didn't think that was necessary for some reason. I just can't picture why.
-Joe
I'm just curious as to why it doesn't move around. any ideas?? There was just a little play in the TRE on the stock bar and everytime I made a turn it sounded like it was going to fall apart. The stock bushing was a close fit to the bolt, but ORGS didn't think that was necessary for some reason. I just can't picture why.
-Joe