OC/LBC drive shaft work

[88trailcrawler]

looking for a good shop or recommended member to rebuild the rear drive shaft.

Pretty sure it came from six states when Ryan put in the SYE. I figured new u-joints but looking at it the grinding is coming from the coupling (I don't know the correct term) between the double u-joints. There is a zerk fitting in there that has been ground away.

Any thoughts? I am guessing new u-joints and coupling thingy, clean and lube up.

 

[johnnyc]

I've always gone to OC Driveline in Placentia.

 

[Kejtar]

Power industries in Garden Grove. Very high quality.

 

[Clean Racing]

I had always used Ray at OC driveline in Placentia, and have used powertrain industries in GG as well. Both real good work..

 

[Original_MudButt]

OC driveline...

The double u-joint is often referred to as a CV joint. But more correctly, it's called a double cardan.

 

[Lurch]

Powertrain Industries x2, its in Gardena though.

16539 1/2 South Broadway Center St, Gardena, CA 90248

 

[Kejtar]

There is one in Garden Grove

 

[peterjford]

I have used OC Driveline before and would recommend them.

 

[88trailcrawler]

FYI. Dropped it off at Powertrain yesterday (much closer to me than OC) picked it up today. They needed to cut and weld an new ball stud yoke. It looks brand new, all rebuilt, cleaned up and painted. Even cleaned up the slip shaft. And gave me all new install hardware.

Probably not the cheapest route, but certainly quick and seemingly very good.