Well, not quite, but it is folding in a most peculiar way...
I have a Rusty's 6.5" long arm that I installed. The long arm mounts sandwich the frame rail and are sleeved so as not to crush the frame rail. However, I noticed that right in front of my driver seat there was a bulge upward in the floor. I was concerned enough that I pulled out the seat, lifted the carpet and holy cow! the floor was bulged up right in between the framerails. The only way I can figure this would happen is if the tops of the framerails were brought together but when I check underneath the long arm mounting plates are good and tight. I hammered it back down so at least I don't have the bulge in the floor anymore. I haven't been really abusing the XJ either.
Anyone else had something similar happen?
I have a Rusty's 6.5" long arm that I installed. The long arm mounts sandwich the frame rail and are sleeved so as not to crush the frame rail. However, I noticed that right in front of my driver seat there was a bulge upward in the floor. I was concerned enough that I pulled out the seat, lifted the carpet and holy cow! the floor was bulged up right in between the framerails. The only way I can figure this would happen is if the tops of the framerails were brought together but when I check underneath the long arm mounting plates are good and tight. I hammered it back down so at least I don't have the bulge in the floor anymore. I haven't been really abusing the XJ either.
Anyone else had something similar happen?