Hey,
Those with Mastercraft seats in their 97 to 01 XJ, I'm installing some rubicon seats with Mastercraft's XJ adapter kit, but the adapter kit doesn't work! One of the stock sliders on each seat will not fit through the adapter kit because the bolt on the stock slider is too short. It would work if they didn't weld on these massive washers to the adapter kit, but they did.... It looks like I going to have to do a little fabrication, and I have a few ideas in mind. I'm wondering what the majority of you all did to make your seats work. I have two ideas...
Drill out the stock welded bolts on the sliders and put in longer ones (not sure if I'll run into problems here...)
Drill off the washers welded on to stock slider..(this is the easiest option, but without the washers, I believe the seat will sit crooked and further down on one side by a half of an inch.
Thanks.
Luke
Those with Mastercraft seats in their 97 to 01 XJ, I'm installing some rubicon seats with Mastercraft's XJ adapter kit, but the adapter kit doesn't work! One of the stock sliders on each seat will not fit through the adapter kit because the bolt on the stock slider is too short. It would work if they didn't weld on these massive washers to the adapter kit, but they did.... It looks like I going to have to do a little fabrication, and I have a few ideas in mind. I'm wondering what the majority of you all did to make your seats work. I have two ideas...
Drill out the stock welded bolts on the sliders and put in longer ones (not sure if I'll run into problems here...)
Drill off the washers welded on to stock slider..(this is the easiest option, but without the washers, I believe the seat will sit crooked and further down on one side by a half of an inch.
Thanks.
Luke