from a project that i never made time to finish:
89 fs jeep wagoneer -
*frame & all workings (minus the waggy body)
running amc 360
TF 727 auto/trans
NP 242 t-case (jeep)
d-44s front & rear (stock 3.54 gears/open)
37" mostly worn SS TSL radials
6 lug white wagons
front leaves Rusty's 6" (spring under)
rear 63" chevy half ton leaves w/ shackle flip (spring over)
sittin atop this pile of AMC is a Chopped Commance truck Cab
-that i've started narrowing the front/ hood -grill -fenders
interior on the cab is stripped ready for rhino-lining
bench seat & 3 - 3point harnesses included..
(also included is the commanchee fule tank & pump)
all the essentail wiring harness/ steering & brake compenentry from the old waggy cab is in need of final connection/calibration but all parts are there.
rear drive shaft needs to be refit with 8" longer tube due to the Chevy leaves.
mainly just needs fab work and wrenching (someone with an adequate workshop could finish this rig into a killer trail best for a very low price..)
$500
located in Northeast AL (Gadsden area)
i had pics online on FSJA.org of the project build at one time..
-
being that i'm in Baghdad - internet connectivity & communication is restricted/limited but if seriously interested- hit my yahoo mail--
-- i get to check it about once per week.
i really need to sell this stuff - moving when i return home.
[email protected]
89 fs jeep wagoneer -
*frame & all workings (minus the waggy body)
running amc 360
TF 727 auto/trans
NP 242 t-case (jeep)
d-44s front & rear (stock 3.54 gears/open)
37" mostly worn SS TSL radials
6 lug white wagons
front leaves Rusty's 6" (spring under)
rear 63" chevy half ton leaves w/ shackle flip (spring over)
sittin atop this pile of AMC is a Chopped Commance truck Cab
-that i've started narrowing the front/ hood -grill -fenders
interior on the cab is stripped ready for rhino-lining
bench seat & 3 - 3point harnesses included..
(also included is the commanchee fule tank & pump)
all the essentail wiring harness/ steering & brake compenentry from the old waggy cab is in need of final connection/calibration but all parts are there.
rear drive shaft needs to be refit with 8" longer tube due to the Chevy leaves.
mainly just needs fab work and wrenching (someone with an adequate workshop could finish this rig into a killer trail best for a very low price..)
$500
located in Northeast AL (Gadsden area)
i had pics online on FSJA.org of the project build at one time..
-
being that i'm in Baghdad - internet connectivity & communication is restricted/limited but if seriously interested- hit my yahoo mail--
-- i get to check it about once per week.
i really need to sell this stuff - moving when i return home.
[email protected]
