i recently went from 2 inch blocks in the back to a 3 inch Procomp complete leaf springs and i think my shocks are maxed out.. they are very difficult to install, first shocks goes on easy but the second shock i have to put a 1 ton jack under the axle to align the bottom hole...
when i had just the 2 inch blocks the shocks were really easy to install/uninstall
i am running RANCHO RS9000 shocks
also the lift in the rear is a little uneven, one side is 1 inch lower then the other.
I am thinking my shocks are too short for my lift
any ideas?
when i had just the 2 inch blocks the shocks were really easy to install/uninstall
i am running RANCHO RS9000 shocks
also the lift in the rear is a little uneven, one side is 1 inch lower then the other.
I am thinking my shocks are too short for my lift
any ideas?