- Location
- Parke County, Indiana
Around three weeks ago, I put my lift on the MJ. Got everything done, ready to drive besides the brakes.. Went to bleed the brakes and couldnt get pedal. Replaced the master cylinder with a rebuilt one, Master cylinder went bad, I repeated this 4 times. The last two were new ones. I do not know what is going on.
First I thought I wasnt getting brakes because of the porpotioning valve, so i put one on there from a 94 Cherokee. well, everything was fine, but the master cylinder leaked. I never could get brakes.. I could get a lil' pedal, but it would not hold.. If you held on it, it would go to the floor. What am I doing wrong?
When I did the lift, I also replaced the axles, the rear is an 8.8 with disk brakes. The front is a D30, both axles were dry. I also replaced the front rubber lines with wrangler lines. Replaced the rear hard lines, there is only one little section that runs across the engine compartment, and along the frame under the bed. Those are the only old lines on it.
Egg
First I thought I wasnt getting brakes because of the porpotioning valve, so i put one on there from a 94 Cherokee. well, everything was fine, but the master cylinder leaked. I never could get brakes.. I could get a lil' pedal, but it would not hold.. If you held on it, it would go to the floor. What am I doing wrong?
When I did the lift, I also replaced the axles, the rear is an 8.8 with disk brakes. The front is a D30, both axles were dry. I also replaced the front rubber lines with wrangler lines. Replaced the rear hard lines, there is only one little section that runs across the engine compartment, and along the frame under the bed. Those are the only old lines on it.
Egg