Mark WNC
NAXJA Member # 481
- Location
- Western NC
Both 89's
here's some info on the 1st one.
Around 7 to 7.5 inch lift
5-34 10.50 superswamper LTB about half tread on 15-8 wheels
custom alcan leaf springs w/boomerang shackles
rusty's long arm kit with 6.5 coils
rock sliders,steering box brace,and frame stiffener
ACOS
Heavy trac bar and tie rod
5 speed (not pukko) w/231 case and SYE
custom tom woods rear shaft
8.8 rear with lockright and disc brakes
D30 front disco w/lockright
(about wore out, but I have a replacment no disco)
4.88 yukon gears
custom 4x4 rear bumper w/tire carrier
custom 4x4 front bumper w/warn 9000i w/rope not cable
It has a custom quick fix exhaust through
the roof so you do die from carbon monoxide
Its beat up a little some might think alot but who cares
Heres whats missing
rear hatch
rear side windows
Starts and runs good
The 2nd one has a
Rusty's 6.5 lift rear springs and front coils
long arm kit
D30 front no disco w/lockright
heavy tracbar and tierod
steering box brace and frame stiffener
D44 rear w/lockright
automatic trans w/231 case
5-34 10.50 (brand new) superswamper LTB's on 15-7 wheels
all body parts still here unlike the 1st one
Got rock rash in a few places
but in good shape
starts and runs good
I have extra parts
a set of rusty's 6.5 coils (brand new)
a couple front drive shafts
two 231 case's
old pair rusty's 6.5 leafs with spring rap
two sets of short arms, one set fixed and one set adj.
Lots of misc.parts
also have an 87 parts rig cramed full of stock parts
and an 89 rangler no motor,wire harness,trans or case
make good buggy build or at least that was the plan.
you can also have the option of a 24 foot gooseneck
w/custom ramps on neck to haul two jeeps.
$7500.00 for jeeps, parts rig and all parts and wrangler
Gooseneck for an additional $3000 if you take it all.
This all is located in Canton,NC 28716
Serious lookers only, dont have time to mess around
Thanks
here's some info on the 1st one.
Around 7 to 7.5 inch lift
5-34 10.50 superswamper LTB about half tread on 15-8 wheels
custom alcan leaf springs w/boomerang shackles
rusty's long arm kit with 6.5 coils
rock sliders,steering box brace,and frame stiffener
ACOS
Heavy trac bar and tie rod
5 speed (not pukko) w/231 case and SYE
custom tom woods rear shaft
8.8 rear with lockright and disc brakes
D30 front disco w/lockright
(about wore out, but I have a replacment no disco)
4.88 yukon gears
custom 4x4 rear bumper w/tire carrier
custom 4x4 front bumper w/warn 9000i w/rope not cable
It has a custom quick fix exhaust through
the roof so you do die from carbon monoxide
Its beat up a little some might think alot but who cares
Heres whats missing
rear hatch
rear side windows
Starts and runs good
The 2nd one has a
Rusty's 6.5 lift rear springs and front coils
long arm kit
D30 front no disco w/lockright
heavy tracbar and tierod
steering box brace and frame stiffener
D44 rear w/lockright
automatic trans w/231 case
5-34 10.50 (brand new) superswamper LTB's on 15-7 wheels
all body parts still here unlike the 1st one
Got rock rash in a few places
but in good shape
starts and runs good
I have extra parts
a set of rusty's 6.5 coils (brand new)
a couple front drive shafts
two 231 case's
old pair rusty's 6.5 leafs with spring rap
two sets of short arms, one set fixed and one set adj.
Lots of misc.parts
also have an 87 parts rig cramed full of stock parts
and an 89 rangler no motor,wire harness,trans or case
make good buggy build or at least that was the plan.
you can also have the option of a 24 foot gooseneck
w/custom ramps on neck to haul two jeeps.
$7500.00 for jeeps, parts rig and all parts and wrangler
Gooseneck for an additional $3000 if you take it all.
This all is located in Canton,NC 28716
Serious lookers only, dont have time to mess around
Thanks