Okay so this may not be the ideal place for this but I figured I'd toss it up here. Grab a cheap truck D60 and some housing ends and you could make a 5 on 4.5" semi-floater D60 that would be the about the right width for a Jeep with this stuff.
Dana 25124X Powr-Lok. Date coded 11 4 68. Pulled from a B Body Mopar housing. Spins freely, do not know condition of the clutches. 23 spline but a conversion kit is available for 35 spline (link) or use the shafts below. $225 or best offer
Used Dana 4.56 gears, LP. Ring gear currently mounted to the carrier, I can take them off if the buyer of the carrier doesn't want them and to save shipping costs. Free with the Powr-Lok if you want them.
23 spline shafts. Pulled from same B body Mopar housing. Free with the above if you want them.
Actual shipping on your dime.
Dana 25124X Powr-Lok. Date coded 11 4 68. Pulled from a B Body Mopar housing. Spins freely, do not know condition of the clutches. 23 spline but a conversion kit is available for 35 spline (link) or use the shafts below. $225 or best offer
Used Dana 4.56 gears, LP. Ring gear currently mounted to the carrier, I can take them off if the buyer of the carrier doesn't want them and to save shipping costs. Free with the Powr-Lok if you want them.
23 spline shafts. Pulled from same B body Mopar housing. Free with the above if you want them.
Actual shipping on your dime.