ricot83
NAXJA Member #1297
- Location
- newington, CT
The axle:
1990 Dana 30 disconnect 4.10 gears
The plan:
-change seals so I can use the 99 axle shafts.
- Change the knuckles over from my 99 and of course brakes, hubs blah blah.
-Weld a little plate where the track bar bolt goes so I can avoid death wobble.
-Weld on control arm mount skids so I didnt pretzel them
-reinforce the welds on the lower control arm mounts as well
-Possibly change ball joints if needed.
- maybe weld the axle tubes to the housings(vacuum and diff)
- block off the vacuum housing and remove any extra shit that is there.
-maybe a small truss like rusty's I can make from scrap steel ( not sure about this one)
What else would you add to this list, within reason and my price range.......CHEAP ?
1990 Dana 30 disconnect 4.10 gears
The plan:
-change seals so I can use the 99 axle shafts.
- Change the knuckles over from my 99 and of course brakes, hubs blah blah.
-Weld a little plate where the track bar bolt goes so I can avoid death wobble.
-Weld on control arm mount skids so I didnt pretzel them
-reinforce the welds on the lower control arm mounts as well
-Possibly change ball joints if needed.
- maybe weld the axle tubes to the housings(vacuum and diff)
- block off the vacuum housing and remove any extra shit that is there.
-maybe a small truss like rusty's I can make from scrap steel ( not sure about this one)
What else would you add to this list, within reason and my price range.......CHEAP ?
Last edited: