- Location
- Westminster, SoCal
OK, so I have ox ujoints, warn alloy inners and superior outers and I'm trying to put it all together. Sounds like a simple operation, but it's not
Anyways, the problem is that after I disassembled the ox ujoint, it is an extremely tight fit in between the ears of both the warn and superior shafts: it starts going in easy but I can't get it in low enough to have the holes center so that I can press the trunions (I think that's what they're called) in. Anyways I could probably force it to the "centered" position but then I have a feeling that the joints would bind when turning. Any ideas? suggestions?
Thanks
Remi
Anyways, the problem is that after I disassembled the ox ujoint, it is an extremely tight fit in between the ears of both the warn and superior shafts: it starts going in easy but I can't get it in low enough to have the holes center so that I can press the trunions (I think that's what they're called) in. Anyways I could probably force it to the "centered" position but then I have a feeling that the joints would bind when turning. Any ideas? suggestions?
Thanks
Remi