Profesto
NAXJA Forum User
- Location
- Northeast Pennsylvania
I am going to put a jb conversions sye on my 95 xj with a np231. I have the parts for a 5.5"-6.5"(with srb) leaf lift and was wondering if I should go with the cv or non cv yoke. I cannot find a definite answer. My understanding is that with the non cv the pinion has to be parallel with the t case and u joint angles must be under a certain degree but this can be hard to accomplish with higher lifts. And with the cv yoke and shaft you can just shim the axle to basically point at the t case but the pinion angle has to be within a certain spec also. My question is what would be the better route to go or is it just preference and your application. Thank you.