Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
It's a '91 w/4.0. It's the CPS I need to check. I already replaced the cam pos sensor in the distributor after getting code 54. I'm getting fuel and spark, but still a no-start situation. Just cranks.
It's a '91 w/4.0. It's the CPS I need to check. I already replaced the cam pos sensor in the distributor after getting code 54. I'm getting fuel and spark, but still a no-start situation. Just cranks.
Sorry I have no experience w. the post renix chrysler sys you have. However, I understand that your cps recieves an approx 5 volt incoming pwr signal from the ecu unlike the pre 91s. So I would see if you are getting a 5 volt into and out of that connector during cranking. You can do it w. the connector discod to avoid a start re you incoming signal. You can also simply test your connector for resistance by checking for resistance across the connector by connecting into the wires that connect on each side of the connector. Sorry can't help beyond that. In my limited experience bad/dirty connectors are often a cause of problems. Greg