- Location
- REDLANDS, CA. (SoCal)
I thought this was the new train wreck thread. :cheers:
It's not that new!
I'd be done now if I had...
I thought this was the new train wreck thread. :cheers:
Any thoughts as to whether or not I ought to run a bead of body seam sealant along the top of the frame plating?
Complicated? Haha! Notice I haven't mentioned *how* I was planning on bolting mine on?That is my thinking. Although I may even opt to complicate things a bit by welding a boss on the stiffener and threading it such that the bolt becomes one more attachment point
Basically straight up and out.Can the fender lift straight up?
Complicated? Haha! Notice I haven't mentioned *how* I was planning on bolting mine on?
How are you going to get it, though? Aren't you still not allowed more than 600 yards West of I-15?
Woo-hoo! I finally found a SoCal source for the unobtainium component for my rock sliders! Long Beach is MUCH closer than St. Louis, and two weeks sooner. Who would have thought that 2" x 1" x .188 wall tubing would be so fricking hard to find? A few of the places I called even told me it doesn't exist.
I'm beginning to smell Calico in the moonlight.
Benner metals in fullerton should have that.