seigeXJ90
NAXJA Forum User
- Location
- SB Mountains
I went to put my push rods and rocker arms back on my head and noticed one of the rocker arm bridges is bent.. meaning if the left rocker arm is sitting in place..the right one sits a couple millimeters back and is canted a couple degrees to the right.. it doesn't look like it failed at all just... bent...
what would cause this?
valves were all OK when I did my valve job and I have no bent push rods and the pivots are not scratched or warn .. just seems weird to me
am i going to have any issues just replacing the bridge and pivot? (1.99 at autozone)
what would cause this?
valves were all OK when I did my valve job and I have no bent push rods and the pivots are not scratched or warn .. just seems weird to me
am i going to have any issues just replacing the bridge and pivot? (1.99 at autozone)