Tacedaddy
NAXJA Forum User
- Location
- Shenandoah valley
So i finally got all my parts together for my jeep
Header panel from the junkyard with lights and grill $40.00
headlight doors and one turn signal $35.00
and some spray paint $6.00
ok enough talking, MOAR PICHURS
BEFORE
1990 jeep cherokee limited, NP242, with a 3 inch lift
^ yeh my grill was upside down lol... my lights fit better that way
During
since there wasnt a bolt to hold the new header panel on i drilled a hole and used a self tapping screw to hold it on.. but i was out of washers so i had to improvise
and After
I need to take a picture of the body lines but they really line up just fine with the early style fenders
it was really easy, just had to wire the two lights from the new header panel together and tie them into the existing wiring in the jeep for the turn signals to flash, and splice the new marker lamp bulb connectors on because the 1990's one wouldnt fit
also had to adjust the hood forward because i had a 1/2 in gap
Header panel from the junkyard with lights and grill $40.00
headlight doors and one turn signal $35.00
and some spray paint $6.00
ok enough talking, MOAR PICHURS
BEFORE
1990 jeep cherokee limited, NP242, with a 3 inch lift
^ yeh my grill was upside down lol... my lights fit better that way
During
since there wasnt a bolt to hold the new header panel on i drilled a hole and used a self tapping screw to hold it on.. but i was out of washers so i had to improvise
and After
I need to take a picture of the body lines but they really line up just fine with the early style fenders
it was really easy, just had to wire the two lights from the new header panel together and tie them into the existing wiring in the jeep for the turn signals to flash, and splice the new marker lamp bulb connectors on because the 1990's one wouldnt fit
also had to adjust the hood forward because i had a 1/2 in gap
Last edited: