98GhostXJ
NAXJA Forum User
- Location
- Redwood City, CA
I have a 4.5" lift and have installed Rough Country Adjustable control arms. When I did the install I followed the measurments I found on the forum, but now that I have but on the 33's, it is very clear that the axle is still a bit back in the well. I was wondering if anyone that has these control arms and have their axle centered in the well, would take their measurements and post them in this thread. I could just drop each arm and spin them each an equal amount, but I want to do it once and not mess with the alignment any more than necessary If anyone has any ideas on the best way to do this I open to suggestions.
Thanks in advance.
Thanks in advance.