Search results

Got tired of my cup holder falling off around turns with drinks in it. I wanted to countersink the holes to clean the look up, but I didn't have anything big enough. I wanted to use different hardware too, but the tube for the rear vent is in the way unless you pull the center console out...

I had posted before about space behind the headlights because I wanted to install the vleds h4 micro evolution headlight bulbs and was concerned about fitment. Just wanted to give an update incase anyone else was interested in doing this mod. The bulbs fit in my 94 without any cutting or...

So after a fiasco with my suspension upgrade, I finally got my new lift and shocks done. RE 3.5 leafs and RE 1.75 coil spacers. The leafs ended up giving me 5" of lift si I used the coil spacers to help level it and ended up with around 4.75" in the front with OME shocks all the way around. I...

Can anybody tell me how much room there is behind the headlights on the xj? Mine is a 94 and I'm looking to had some LED bulbs since I already have the h4 conversion. The bulbs are supposed to have a smaller rear than most LEDs and only require about 1.6 inches from the h4 lock plate to the...

Does anybody know if the manual transmission xj was available with cruise control? I'm thinking about adding factory cruise to my manual 94. I know with the automatics it's basically plug and play, it looks like the manual should be the same with the exception of the clutch switch. There is no...

Does anybody know where to buy the side louvers that go towards the rear on the 2 door xj? Can't find anything on search or Google except hood vents and 80s louvers for the back glass lol

I'm been looking for a solution to add a threaded temp sensor for my taurus fan swap as I'm not very fond of the radiator probe type. I came across a "high flow" thermostat housing made by hesco that has an extra temp sensor hole. I don't really need or want anything "high flow" since my jeep...

My idler pulley grenaded on my way into work last night. I got a gates replacement pulley from O'Reilly, but the dust cover for the front of the pulley will not fit in the inside diameter of the new pulley. The pulley did come with a new "spacer" but I'm not sure if it should go on the front or...

The engine keeps dying randomly on my 94 xj. It's a manual transmission and the rpms drop to 0 when the engine dies instead of still showing the engine speed as the engine slows down in gear. I originally thought it was an electrical issue, but all other electronics still work when the engine...

My silverstar headlights finally crapped out and it's time to upgrade. I was planning on each codes and a harness upgrade, but I came across a youtube review of the cree headlights and they looked pretty good. Did a search here, but didn't really find anything reviewing them. Anybody running...

I bought my xj with a lift already on it, not sure what brand but it's lift coils up front and blocks in the rear. Wasn't sure on the lift height so I did the hub to flare measurement, measured out to 3.75 in the front and 3.25 in the rear. I'm assuming that it's a 4 inch lift that has sagged a...

Anybody running the 15x8 Rubicon xtreme wheels on their xj? Thinking about buying these wheels, looking for some pics of them on an xj

Turned off my ignition this weekend, noticed it was kinda stiff when turning off. Ignition cylinder turns and seem to function properly except for the cranking(it also doesn't seem to "spring" back into the on position after trying to crank). I think it's the actual electrical part of the switch...

I got a set of ecco wheels and swapped my 31x10.50s onto them. I know others are running this same setup, but after I put the eccos on my xj the tires are rubbing my swaybar endlinks on the rear axle. I know the backspacing is different from my old wheels, but others don't seem to have this...

I'm having a strange lock issue with my 94 2 door. I have manual locks and sometimes they work perfectly. Other times my key will not unlock the drivers door. The key turns and everything, it just won't unlock. Eventually I can get it to unlock but it takes a few tries to get it to unlock. Any...

I'm thinking pretty hard about doing a bed liner paint job on the xj but not sure on color yet. So if you've got rinoliner, raptor, monstaliner, line x, krylon, or whatever, let's see some pics! Let me know what brand you used, color, and how you like it.

Looking for either grizzly, ecco, or icon wheels. Looking for a set of 5 but may take a set of 4. Pm me if you have a set for sale. I'm in Safford, AZ but will be in Mesa for the weekend and travel to Tucson regularly. Thanks

I've always loved the grizzly wheels since I first fell in love with the xj. I want to switch my wheels out for the grizzly style but I'm not sure if my 31x10.50s would be good on them. I'm also not sure what lift I have so I don't know if they will have the backspace I need. Here's a pic of the...

So I just got my 94 xj and it's already got some work into it. It has an electric fan that looks factory but not positive. The electric fan is wire to a switch to turn it on, and it also turns on when running the air conditioning. My question is, with it being tied to a switch, will it still run...

I just bought a 94 xj with a 5 speed and it's my first 4x4. So far I really like it. It's got probably a 3"-4" lift running 31x10.50s. The only thing I don't like about it is that it will do 80mph no problem, but when I start climbing hills on the highway I have to downshift to maintain that...