Search results

PM'd

I won't be DD'ing it for much longer. Another year or so. And my 33's have about a year of life left. If I was going to keep it as a DD id stick to 33's

Thanks everyone for the advice so far.

I found a gearing chart that takes into consideration the transmission and xfer case. Pretty handy. http://www.grimmjeeper.com/gears.html You're right about hills for sure. I live in Nebraska where it is relatively flat. But I'd driven this jeep back and forth to the east coast about 10...

:wierd: I have 33's now and run 3.55s. Its not bad at all. I still have plenty of power to pass, and I get 17-18mpg highway with a 6.5" lift and 33s. I've been looking at gear ratio charts today after reading your post and I can't seem to figure out how they would be relevant without...

The Jeep: 97 XJ. 220k on the clock. 6.5" lift. 33" Duratracs. D30 front (no idea on spline count) and a D35 in the rear. 4.0, automatic, 3.55 gears. The plan: Trashing the D35 and going with either an 8.25 or an 8.8 depending on what I can find at the junkyard. Also my Duratracs have...

Its a 97. No factory fogs. I had no issues with the headlights before installing the H4s. The headlight delay works fine. They stay on for however many seconds it is if you turn the lights off AFTER the ignition. But if you turn the lights off before you turn off the ignition, the...

A few years ago I installed IPF H4 headlight housings and some H4 bulbs. I used the LMC truck harness. Ever since my headlights will not turn off when I turn the lights off while driving. Not a huge deal which is why I have basically ignored it for so long. But for whatever reason it is...

I don't have Daytime running lights

what is a DRL module?

Its a 97 and I don't have fog lights.

Did this ever get resolved? I have an LMC truck harness and my headlights will not turn off while the engine is running unless I flash the high beams.

Replaced TPS with MOPAR part. Problem resolved

Please forgive me if this gets a little bit long, and I give you unnecessary information but I want to give you all as much information as possible. 97 XJ 4.0 w/ AW4. 190k I was driving my XJ cross country (3000 mi round trip) that I make 2-3 times a year for the past 3 years. Up until the...

Trying to list some things for sale, but it won't let me make a thread. What gives?

Thanks for the advice!

I replaced my rear drive shaft with an Adams shaft. Will the old one ever be of use to me? It has some bad U joints I'm sure because all the drive train noise I had before is now gone with the new Adams shaft. Just want to check before I throw it out...

Yeah that came to mind. Too bad it didn't come to mind until I finshed my SYE install. :dunce:

Anybody know the size needed for the factory drain and fill plugs?

I'm generally not fond of a vehicle fluid I cannot monitor. I want to remove the drain and fill plugs and replace them with hose fittings and run a clear piece of tube between the two so I can monitor the level of fluid. I'm sure this has been done before, it is not some brilliant or new idea...