Search results

99 XJ 5 speed 4.0 Okay so maybe someone on here can help me out with this. I have an np231 with an Sye kit in it. The tail shaft seal leaks. IM giving it a quart of atf fluid almost every a week. The seal is an easy fix that i am more than capable off doing. The trouble is Idk who makes this...

99 XJ 4.0 AX15 Gas Gauge does not work and check engine light is on. The code is p1492 ambient/ battery temp sensor voltage to high. The Alternator is not charging the batter. I replaced the battery temp sensor r the battery and the alternator. And i still have the same problem. I am at a loss...

99 XJ 5 speed Dana 35 4.5~5 inch lift my original transfercase locked up and died. i was able to but one from friends that has an sye in it he does not remember what brand the slip yoke eliminator is. I measured from transfer case yoke to rear axle pinion yoke and it looks to be about 34...

99 XJ 4.0 Ax15 Was driving home from school yesterday on the highway when the 2 month old u joint bindrd up on me and caused the rear drive shaft to propel underneath my jeep. Buddy came to the rescue with a tilt trailer and a pickup cause I had my front one out while I was rebuilding upon...

‎99 XJ 4.0, AX15, NP-231 okay so i got a grinding/scraping noise when my foot is on the clutch pedal it ocasionally will go away when it is fully depressed and come back at about 1/2 way and sometimes it will do it no matter how much the pedal is depressed. im thinking its a bad throw out...

99 XJ 4.0 AX15 about 5 inches of lift My Cherokee has about 5 inches of lift it currently has rusty's shocks and a 6 leaf pack in the rear it does great in turns and ive put car trailers with cars on the back and have gotten very little saggage but it rides like a brick would a different set of...

1999 XJ 4.0 AX15, NP231 Hey guys, My XJ is going to be need a new set of motor mounts sometime soon i was wondering who makes some good ones. I'd like to stay away from the autozone ones cause i had a friend use them and they werent all that great. (what's your experience with them?) How about...

A friend and i ran into an old XJ behind a an old warehouse. it's a 1984-1986 with a 2.8L v6 however it is the Cherokee Chief and it is fully loaded with power everything. it has the selec-trac transfer case. this is our first time ever seeing a selec trac transfer case like this it had the...

99 4.0 5 speed So yesterday i bought a jet stage 2 preformance chip for my truck guy was asking 50 bucks so i figured y not. I have a cold air intake pacesetter headers and a flowmaster exhaust i plugged the thing in drove my truck home and didnt really notice that much of a differance. My...

1989 MJ 4.0L BA10/5 NP231 so recently my friends MJ with the BA10 tranny has had a really loose shifter lever it flops from side to side. It's like there is no spring in it at all. because of this when it is in 1st and 3rd the shift lever gets pulled down towards neutral which causes some...

I know this isnt XJ or MJ related but... recently the WK2 ( 2011 Grand Cherokee) went in to get a new set of tires on the front and rear axle a four wheel alignment was also ordered the tec at the tire place called town fair tire came back and said that the left rear wheel toe in bar is bent...

1989 MJ 4.0L BA10/5 my friend has a 1989 MJ that is not getting any spark (not even from the coil itself) nor is it getting fuel. we currently have done the following changed the CPS changed the Coil had the ICM tested at autozone which tested fine jumped the connection for the fuel/ignition...

1989 MJ with a 4.0 Litre So my buddy bought himself a 1989 Jeep Commanche Pionner with a 5 speed manual transmission. him and i have been trying to figure out weather or not he has the AX15 or the Peugeot BA10/5. I got a build sheet for his truck from Chrysler it came back as DDX heavy Duty 5...

99 xj 4.0 ax15 Recently i have had ocasionally problems while shifting into 3rd and 4th the lever will abosutely refuse to go into those gears. It takes moving the shifter lever around and banging on it to get it to go in gear tranny has clean fluid i know for a fact its not in the forks cause...

99 xj 4.0 ax15 Hey guys, not sure if this is tech or not but my XJ's horns keep dying from the mud that i encounter from off-roading or if i drive in the rain alot. I am on my 4th set of horns and i am thinking about relocating the horns. I cannot do any sort of air horn upgrade or anything...

99 XJ 4.0 AX-15 Hey, so the pervious owner on my jeep had the tranny rebuild somewhere down in SC about 50,000 miles ago, they put a GL-4 fluid in without him knowing (i found this out when changing the fluid and smelt a sulfur smell when draining the fluid I put in a Synthetic 10W-30) but as...

1999 XJ 4.0 AX15 so when i bought this jeep it didnt have the keyless entry remote but it does have key less entry. i bought a new one off ebay for 10 bucks and did some digging around on how to program it. it turns out the only way it can be reprogrammed is with a DRBIII scan tool. So i...

so i have pacesetter headers on my truck they are a bit rusty and i want to paint them cause i cant afford to replace them ik i need header paint but as far as prep work goes anything special i got to do besides sanding?

a few Cherokees made the news today lol http://autos.aol.com/article/georgia-man-speeds-down-interstate-with-crying-girlfriend-on-hoo/ http://www.aol.com/video/morning-rush-viral-92012/517484378/?icid=maing-grid7%7Cmaing6%7Cdl15%7Csec1_lnk1%26pLid%3D208318

99 XJ 4.0 AX15 3.55's so my buddy has a 8.25 rear axle he is willing to sell to me. the only issue is it's got the stock manual transmission gears of 3.07's can i use the gears outta my D35 and put them into the 8.25 or will that not work i asked my buddy whos selling the 8.25 who knows alot...