Search results

I have a '99 XJ 2 door and I replaced the door seal with an aftermarket one and it's super stiff. I cannot shut the door anymore without slamming it. From the inside the door handle nearly breaks off to open the door. I have tried already to adjust the door pin and if I adjust it out I can...

Specs first, 1987 Jeep Comanche had 4.0L 2wd ba-10/5 Installed aw-4 trans, 242 case and all under hood wiring and fuse box from 1990 XJ. Ran fine until I noticed the flex plate knock. Thought it was a rod bearing so I decided to install my stroker motor. '96 block and head, kept all the...

I have searched the net and the forum and can't seem to find an adapter to pressure test my system. I have a Matco cooling system pressure tester but it doesn't have the adapter to screw onto the OE pressure bottle. Does anyone have a link to the part I can buy? Thanks!!

I have a 4.7 stroker with the aFe stainless header. This is in my Comanche 4wd short box. I plan on someone making me an exhaust 2.5" single inlet muffler, dual outlet and 2-1/4" tail pipes. No cat. I have a '99 intake on a '96 block and head and I need TWO O2 sensors, one for the Renix...

I bought a new yellow top optima for my Comanche but the OE battery tray is WAY to big and sloppy to mount it securely. What did you guys do to yours? Is there a specific tray you can get that is the same contour of the battery with a new hold down? Pictures of your setup would be very...

Has anyone ran accross someone that rents the hydraulic flare tool to make steel fuel lines? I don't want to cobble my fuel lines in my engine bay.

I have been doing some research on a wideband O2 gauge setup and I have been told to get an Innovative but from the comments I have read most people have had a LOT of problems with them regarding error codes which means sending them back and buying new O2 sensors. So which one should I pick to...

I changed the valve cover of my new to me 4.7L stroker, I was alarmed by the way the pushrods were sitting crooked on the rockers. I took pictures on how off center the pushrods are sitting in the holes in the heads. They are close to grinding on the sides! I repositioned them by turning the...

I have a 4.7L stroker motor that I will be installing in my '87 Jeep Comanche. Specs are '96 block and head, '99 intake with 62mm aluminum throttle body. I will be using the renix system to control it. Questions. What do I need to properly keep an eye on the motor other than standard...

I have an '87 Comanche 4wd that I have a 4.7L stroker built for it. I cannot for the life of me find difinitive information anywhere on the internet as to which exhaust header fits without mofication to the intake or exhaust. Have: 4.7L stroker motor with '99 intake and aluminum bored...

I have a Christmas gift from my lovely fiance I'm working on. It's a '90 XJ with the 241 transfer case. Last night I put it into 4wd and all the transfer case did was make noise like the gears were't engaging. I tried to put it into 4wd FT, PT, LOW and back to 2WD but no luck. Had to tow it back...