Search results

If you look at the steering shaft near the firewall, there is a vibration damper built in to the firewall end U-joint. (some photos of an aftermarket damper here http://www.borgeson.com/VibrationDamp.htm). The vibration damper is essentialy a hollow cylinder of rubber with one end of the...

Check the vibration damper in the steering shaft. I bet it's starting to slip under high loads. Doug

I've got a diamond no-ground-plane dual band antenna (NR770HNMOB) on the front drivers side fender, about 1/2 way down the hood. It fits into the garage, but only barely (about 2-3mm clearance). If I need more clearance, it's got a manual fold over built into the antenna, and I just lean it...

Here's mine. Doug

It looks like I'll be driving down from denver for the day on Saturday. I'm fairly new to the area, (and the board) but I think I can find the place. Doug

I've dealt quite a bit with serious auto, which is the same company as cibielights.com. They were about 45 minutes from me when I lived in Monterey. Larry (the owner) is a good guy. Doug

I got similar h4 connectors from napa, and it was not too difficult to take them apart, de-solder the 12ga pigtail, and solder them up to my 10ga harness. It realy depends on where the heat is coming from. If you are getting the heat from the filiment conducted back into the socket then this...