Search results

First off, 1996 Cherokee sport 4.0, auto trans, and I tried to search for this. Here's the short story: So I was using my right turn signal a few days ago and all of a sudden my column starts smoking from where the tilt lever is. A fuse or something blew, and the turn signals stopped working...

I just got some new shocks for my Jeep that are extended for my lift. They don't come with the bar pins in the bottom for the front shocks though. I tried to press the old ones out of my other shocks but they don't seem to come out very easily, as I almost broke a bench vice trying to do it. And...

So, I'm still doing my lift...a day and a half later. I wrote about this yesterday when my LCA bolts that go through the frame were seized up on the bushing inside the LCA. I still haven't gotten that out on either side... I did however get my springs and the sway bar links in. So the front is...

I wish I could go back to '96, before time and rust and all that good stuff set in on all of my bolts...So I'm putting my lift on tonight, it's a RE 3.5" kit w/ rear leafs. I started on the front and went to take the lower control arms off but the end that attaches to the frame is horribly...

Anybody else ever deal with this? Wnenever I let off the gas pedal the idle drops low, into the 250-500 RPM range. It recovers after a second or two and then its fine, but sometimes it dies completely and I don't notice it until I try to steer or look at the tach. I don't think it has to do with...

I just got my RE 3.5 lift a few days ago but haven't installed it yet. What I need to know is if anybody has done this lift and put on Monroes and what part #s they used. I have Monroes on it now and I have friends at the parts store who will warranty them out for whichever ones I need but I...

On my 96 there is a light sensor in between the sun visors up on the roof. What the heck is this thing for? I know in the newer GMs they have them up on the dash to control the daytime running lights but the XJ doesn't have DRLs so what are they used for?

I'm putting on a K&N FIPK that I just got. ( I know... don't flame me, I know the filter sucks and I'm getting a different one for it, I just like the intake tube.) I also have a Poweraid throttle body spacer on it. Anybody else ever done both of these on the same Jeep? What did you do for hood...

Ok everybody I'm new to the board so first off I'd like to say hi to everybody. I've been reading information from this site now for a long time but I finally registered not too long ago as I'm having some problems that I can't quite diagnose, and given the wealth of information between the...