Search results

I just had some done at a Sticker Shop. Less than 5$.

Nice fab work, but... 2$ at Home Depot...

Why should they give give it to you? Do they work for free over there? I would try an oil filter wrench, good luck.

I installed a set of Bosch H4 housing with Silverstar bulbs and the results are great. No upgraded harness.

Good point. The front 2 holes were reinforced with a 3/16 angle bolted to the front face with a backing plate. Plus I added a piece of flat stock that goes to the 1'' hole in the frame and bolted true.

3.0 CRD nuf said

The fogs are FF75. The round ones are from Princess auto. I plan on converting them to HID. I tried a fairlead from a Superwinch my buddy gave me but it did not line up with the spool. Because the winch is bolted to the front, the bottom bolts need to line up. I would need a diffent hawse...

The paint is actualy Sterting Gray Metalic from Ford...

Almost done, just need to wire...

I guess its just the camera angle making it too long. Here are some more shots.

It sticks out 2'' more than the the stocker. It is smaller than an ARB. The winch will be inside of it.

A 10000 winch is going inside, 2 7'' spotlights and 2 Hella FF75fog will be cut in the sides.

Don't waste your time, ARB is the way to go for a locker in an 8.25. They built it, we buy it. For Eaton to to produce a locker for the 8.25 is like waking up 10 years late...

never mind the parts, are you buying just the leafs springs or the entire XJ. There is NO rust on this rig. No getto parts or install. Maybe I don't understand something here, who cares what brand the leafs are when you buy a jeep. Ok you could vary the prince by 150$ but other than that the...

Tadah! Ford Sterling gray metalic

It can only be done with a SYE, will not drive beter. What you need is a Honda.

My small shop and little workbench.