Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
had the same issue in my wifes 98 classic. noise when turning ..been happening for a few months. well today i was making a run to the local autoparts store to get a caliper for my 2 door and BANG noise when turning..long story short...front spider gears busted in frt diff???
pulled the axles and...
the spring clips on the new throw out bearing, are they supposed to be fastened some way to the throwout fork? I just lined them up with the slots on the fork. I think that may be the problem
I installed a new clutch,pressure plate,throwout bearing,slave cylinder,and flywheel. I used a vac bleeder to bleed clutch. Have a steady stream of fluid from slave bleeder.I can not get the transmission to go into any gear with it running.I can put it in first and start the engine and it...
good timing on your post. I sent it down to machine shop, and for $55 they would machine it. Called a local parts shop we deal with here at bmw and they sold me a new for $90.
Thanks for all the suggestions. I Broke the extractor trying this. I was able to borrow a plasma cutter and removed the bolt heads.... Trans out, flywheel heading to machine shop today...THanks Again
trying to drop tranny on my 95 4.0 5speed. I found the top E-12 bolts half ground off.....I can not get my cutoff wheel in there with out hitting the bellhousing....any suggestions????? Thank you