Recent content by spinnerdog

change the master cyl to a dual 96' and better and get the porp valve from a grand cherokee with 4wheel disks. (GRAB THE BOLTS FROM THE REAR CALIPERS THEY WORK BETTER THAT THE ALLEN HEAD IN THE KIT) bleed appropriatly and all should be good. I to have the tera flex kit, they are not very...

want to see some great horns go to (hornblasters.com)

I have installed the shackle kit, and it works perfectly. Lots of measurements but it is right. It looks like you might have one of the brackets that attaches the leaf spring backwards.it can happen. or you have two different leaf springs. Haveing the perch uneven will really cause the unlevel...

Yes you can but not with a carbed motor. The motor must come from the same year or newer with more stringent smog reg's. So you have a 94, the motor must come from a 94 to 2010 vehicle. You can only go forward with an engine not back.

That bumper looks great ,But those are tie down ring's I rip them off of my equipment trailer all the time. Try making a set of D-Ring holders that get welded all the way through the bumper. That will be much safer of a recovery point.Throw some lights recesed into the bumper that would look...

After I put a 4.5 lift on my XJ, I had nothing but problems with the ABS system.From lights staying on to a whole new ABSpump from the dealership. Still problems more problems. Most of the time the pump went into default mode and I had no ABS anyways. SO after 2 new pumps 1 new master...

Chuck the abs system and pull the bulb out, You will be much happier. Your brakes will work like they were built to do.

I have flat towed my xj for roughly 18,000 miles. Never have I ever had to pull a drive shaft for anything. Even with 4:10's the transfercase stays nice and cool. Never had brakes either. Towed behind my exploder, the truck and the motorhome never a problem. But behind another XJ I would do a...

I found that the inside of the splined end wears really funny without the sye installed. This leads to a comprimised contact area and vibrations later on.Not to mention a very weak link!

use three inch ones and cut them down to the right size. I ordered some from summit. I think it was like 15$ for a set of moser ones, much easier that way. Aftermarket rims come in all sorts of thickneses so measure thee times cut once

So you are saying that most halogen lamps can be converted to hid with a kit

I got a set of the new hangers and holy frigen shit!!!!!!!!!!!!!!!!! what a great ride. worth every penny I spent. Now if I can only get the tire to line up in the wheel well again that would be nice.

For E-brake cables try Control Cables in southern calif. They make all E-brake cables, and right the first time (562) 949-0455

I just used the old parts by grinding off the rivet that hold the old stuff to the old handle, and used a bolt with a locking thread to bolt it back together. put a small L bracket on the small hole on the top right of the new bracket to hold it down.I also was able to use the old gasket bucket...

why not get a hold of control cables in southern california and have them make you a set of cables that fit right the first time they make all the cables for the aftermarket brake kits. bear ssbc tera-flex and all sort of others . Kinda is a SECRET so don't tell to many about it 1 562 949-0455