• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by Sidewinder CC

  1. S

    You guys ever seen this? Pin holes in head

    Some more freeze plugs on the side of the block: . And a bad boy under the bell housing: .
  2. S

    Exhaust manifold bolt size?

    The nuts are 3/8-24. Lowes may have these with free spinning washer nuts similar to the OEM nuts, otherwise use a washer under the nut.
  3. S

    2000, coolent temp spikes out of no-where!

    The other day a poster on another Jeep XJ forum had a similar problem. He found bad connections inside of the ECT sensor connector. Replaced the connector and it fixed his problem. You might try having someone sit in the drivers seat while the engine is running (parking brake set) and look at...
  4. S

    Replacing trans inverse torx bolts!?

    The Bell Housing is pass thru. The treads are in the cast iron block. The factory bolts are grade 8 for a reason. I don't see the reasoning behind anyone wanting to use grade 5 bolts in this application. The OP is aware of the source of grade 8 flange bolts (from another forum).
  5. S

    BUMPER BOLT SIZE

    They're M10x1.5 button heads but I can't remember the Torx bit size (sorry). You may want to take several sizes with you.
  6. S

    P0107 MAP sensor

    Try these tests of the MAP sensor. Read the notes as well. . . Switch to RUN, engine off. . Engine at idle. .
  7. S

    98 XJ Coil Driver

    Coil test procedures: . Cracked coil: .
  8. S

    Throttle position sensor - Voltage on output wire

    FYI, here's a TPS test procedures chart. I use a safety pin as a back probe. .
  9. S

    Original spark plugs 2000 4.0?

    Here's a spark plug application chart and a tech tips letter pertaining to the use of NGK ZFR5N plugs. . .
  10. S

    P0705, how to test aw4 shift solenoids

    2001 diagnostics manual: P0705-RANGE SENSOR When Monitored: Continuously with the key on. Set Condition: No Transmission Range Sensor signals are received or two conflicting signals are received from the Transmission Range Sensor at the same time by the TCM. POSSIBLE CAUSES PCM PARK/NEUTRAL...
  11. S

    P0705, how to test aw4 shift solenoids

    Recommend using safety pins to insert in to the connector pin cavities when doing the tests.
  12. S

    No bus

    P1694 is a fault in companion module - No CCD messages received from the PCM - AW4. P1698 is no TCM message from TCM. In the past there have been reports that the TCM has caused your fault(s). Try unplugging the TCM and see if the NoBus message goes away and all gauges work. If so, replace...
  13. S

    Fuse Issues

    Pic of PDC fuses. '97 is pretty much the same. I only see one 25 Amp mini fuse. . '97 PDC diagram: .
Back
Top